To get the latter from the former (which is what we need, as the adjacent is the text height and the opposite is the text movement), you have to multiply the former with the tangent of the angle, since tan(angle)=sin(angle)/cos(angle) and the fraction dividers are reductible on such multiplications: * tan(angle) = * =. The catheti or sides of the right triangle are hypothenuse*cos(angle) for the adjacent one and hypothenuse*sin(angle) for the opposite one. In this case, I didn't even need to deal with matrix multiplication like balala mentioned, it was a matter of simple right triangle geometry. No problem, I hope you'll be able to use the info in your other skin.
Rainmeter flipclock how to#
I could not figure out the offset because the skin is scaled using that same TransformationMatrix (i.e., I know how to scale it, and I know how to skew it, but I could not figure out how to do both at the same time).
If needed, I'll be happy to help you with this, if you are asking.Ĭool, thanks! I was actually needing this info for another skin I am using, so I'll give this a shot. Recommend to read it carefully, or if you're not got used to work with matrices, you probably will have to read it more times, but finally you can figure out how to do. If you don't know how to do this operation, there are sites which can do this for you ( this for instance).Īll related questions get very good answers in the Multiple Transformations in One! section of the Transformation Matrix Guide. Most important thing to keep in mind, is that the order of multiplication does matter this time (unlike in case of multiplication of numbers, where the order doesn't matter). This procedure is a completely basic procedure in matrices operations, but obviously it's not obvious for all. Then you have to multiply those matrices together, according to the corresponding rules. To apply two TransformationMatrix options to the same meter, you have to create both options as if each of them would be applied without the other. (i.e., I know how to scale it, and I know how to skew it, but I could not figure out how to do both at the same time). Select this entry and your flip clock screensaver will be activated.SilverAzide wrote: ↑ March 21st, 2023, 8:53 pm Now, open the Screensaver app again, and you'll see that there's an entry for Gluqlo there. Save the file after making this change and close it. Once opened, head to the programs: section in the file and add the following line: Just close the Screensaver app and open the ~/.xscreensaver file using Gedit or any other text editor of your choice. If that's the case with you as well, don't worry. Ideally you should see an entry for Gluqlo in the scrollable list in the app's UI, but more likely than not, it won't be there. Now launch the Screensaver app from the Unity Dash:
Rainmeter flipclock install#
Sudo apt-get install xscreensaver xscreensaver-gl-extra xscreensaver-data-extra These can be done through the following commands: sudo apt-get remove gnome-screensaver
Rainmeter flipclock download#
Here are the commands that you need to run in order to download and install this tool: sudo apt-add-repository ppa:alexanderk23/ppaīefore you go ahead and launch this tool, you need to remove the gnome-screensaver package and install XScreensaver on your system. To set up the above shown wallpaper, you need to install a tool dubbed Gluqlo. Interested in installing and setting it up on your Ubuntu box? Here's how you can do it:īefore we proceed, please note that all the instructions and commands mentioned in this tutorial have been tested on Ubuntu 16.04 LTS. Looking for a cool screensaver for your Ubuntu system? One that also serves some purpose - not just those beautiful scenery types? How about one that shows current time? Specifically, I am talking about the flip clock screensaver shown below:
0 kommentar(er)
